- ページ 9

換気フード Whirlpool 30 " Eye-Level Gas RangeのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 30 " Eye-Level Gas Range 48 ページ。 Freestanding gas range with self-cleaning oven
Whirlpool 30 " Eye-Level Gas Range にも：取付説明書および取扱説明書 (32 ページ), 取付説明書 (11 ページ), 取扱説明書 (28 ページ), 取付説明書 (11 ページ), インストレーション・インストラクション (5 ページ), 取付説明書 (28 ページ), 取付説明書 (32 ページ), 取付説明書 (12 ページ), インストレーション・インストラクション (5 ページ), 取付説明書 (7 ページ), インストレーション・マニュアル (7 ページ), 取付説明書 (7 ページ), インストレーション・インストラクション (5 ページ), 取付説明書 (7 ページ), 取付説明書 (10 ページ)

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation

instructions.

Slide range back so rear range foot is engaged in the

slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed

and engaged.

Failure to follow these instructions can result in death

or serious burns to children and adults.

1. Remove the anti-tip bracket from the inside of the oven.

2. Determine which mounting method to use: floor or wall.

If you have a stone or masonry floor, you can use the wall

mounting method. If you are installing the range in a mobile

home, you must secure the range to the floor.

This anti-tip bracket and screws can be used with wood or

metal studs.

3. Determine and mark centerline of the cutout space. The

mounting can be installed on either the left side or right side

of the cutout. Position mounting bracket against the wall in

the cutout so that the V-notch of the bracket is 12½"

(31.8 cm) from centerline as shown.

Centerline

A. 12½" (31.8 cm)

B. Bracket V-notch

Install Anti-Tip Bracket

4. Drill two ¹⁄₈" (3 mm) holes that correspond to the bracket

holes of the determined mounting method. See the following

illustrations.

Floor Mounting

Rear position

Front position

Wall Mounting

5. Using the Phillips screwdriver, mount anti-tip bracket to the

wall or floor with the two #10 x 1⁵⁄₈" (4.1 cm) screws provided.

6. Move range close enough to opening to allow for final

electrical connections. Remove shipping base, cardboard or

hardboard from under range.

7. Move range into its final location, making sure rear leveling

leg slides into anti-tip bracket.

8. Move range forward onto shipping base, cardboard or

hardboard to continue installing the range using the following

installation instructions.

Diagonal (2 options)