- ページ 11

換気フード Whirlpool GH6177XPBのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool GH6177XPB 24 ページ。 Microwave hood combination
Whirlpool GH6177XPB にも：取扱説明書 (9 ページ)

4. With front of microwave oven still tilted, thread power supply

cord through the power supply cord hole in the bottom of the

upper cabinet.

5. Rotate microwave oven up toward upper cabinet.

NOTE: If venting through the wall, make sure the damper

assembly fits easily into the vent tube in the wall cutout.

6. Push microwave oven against mounting plate and hold in

place.

NOTE: If microwave oven does not need to be adjusted, skip

steps 7-9.

7. If adjustment is required, rotate microwave oven downward.

Using 2 or more people, lift microwave oven off of mounting

plate, and set aside on a protected surface.

8. Loosen mounting plate screws. Adjust mounting plate and

retighten screws.

9. Repeat steps 3-6.

10. With the microwave oven centered, and with at least one

person holding it in place, insert bolts through upper cabinet

into microwave oven. Tighten bolts until there is no gap

between upper cabinet and microwave oven.

NOTES:

Some upper cabinets may require bolts longer or shorter than

3" (7.6 cm). Longer or shorter bolts are available at most

hardware stores.

Overtightening bolts may warp the top of the microwave oven.

To avoid warping, wood filler blocks may be added. The

blocks must be the same thickness as the space between the

upper cabinet bottom and the microwave oven.

A. Bolts

For Roof Venting Installation Only

1. Insert damper assembly through the cabinet cutout so that the

long tab of the damper assembly slides under the raised tabs

of the damper plate. Then secure with screw removed in

Step 1 of "Rotate Air Deflector."

NOTE: The screw cannot be installed if the damper assembly is

not positioned as shown.

A. Raised tabs

B. Damper assembly

C. Screw

D. Upper cabinet cutout

E. Long tab

F. Damper plate

2. Connect vent to damper assembly.

A. Vent

B. Damper assembly (under vent)