- ページ 8

換気フード Whirlpool GXW7330DXS0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool GXW7330DXS0 28 ページ。 30" (76.2 cm) and 36" (91.4 cm) wall-mount canopy range hood
Whirlpool GXW7330DXS0 にも：取扱説明書 (28 ページ)

ページを印刷する

Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket with

2 - assembly screws provided with the Recirculation

Kit.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

2. Remove the grease filter. See "Range Hood Care" section.

3. Level the range hood and tighten upper mounting screws.

4. Install 2 - 5 x 45 mm lower mounting screws and tighten.

1. Install transition on top of hood (if removed for shipping) with

2 - 3.5 x 9.5 mm sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over transition piece.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

A. Ventcover bracket

B. 2.9 x 6.5 mm screws

C. Deflector

Measure from the bottom of the air deflector to the bottom of

the hood outlet.

A. Air deflector

B. Ventclamp

C. X = length to cut vent duct

D. Ventduct

E. Exhaust outlet

Cut the duct to the measured size (X).

Remove the air deflector.

Slide the duct onto the bottom of the air deflector.

Place the assembled air deflector and duct over the exhaust

outlet from the hood.

Reassemble the air deflector to the duct cover bracket with

2 assembly screws.

Seal connections

with vent clamps.