- ページ 10

換気フード Whirlpool GXW7336DXS0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool GXW7336DXS0 28 ページ。 30" (76.2 cm) and 36" (91.4 cm) wall-mount canopy range hood

IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
IMPORTANT: Do not use soap-filled scouring pads, abrasive
cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths
or paper towels.
To avoid damage to the stainless steel, do not use cleaners that
contain chlorine.
Cleaning Method:
Rub in direction of grain to avoid scratching or damaging the
surface.
Stainless Steel Cleaner and Polish Part Number 31462A (not
included):
See "Assistance or Service" section to order.
Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
Glass cleaner to remove fingerprints.
Metal Grease Filter
1. Remove each filter by pulling the spring release handle and
then pulling down the filter.
A
A. Spring release handle
10

RANGE HOOD CARE

Cleaning

2. Wash metal filters as needed in dishwasher or hot detergent
solution.
3. Reinstall the filter by making sure the spring release handles
are toward the front. Insert aluminum filter into upper track.
4. Push in spring release handle.
5. Push up on metal filter and release handle to latch into place.
6. Repeat steps 1-5 for the other filter.
Replacing a Fluorescent Lamp
Turn off the range hood and allow the fluorescent lamp to cool.
1. Disconnect power.
2. Remove the screw from the lens cover and remove the cover.
3. Remove the light from the socket and replace with a 120-volt,
13-watt (maximum), 50° fluorescent light with a GX24 base.
4. Replace the lens cover and screw. Tighten the screw.
5. Reconnect power.
If new light does not operate, make sure the lamp is inserted
correctly before calling service.
C
B
A. Screw
B. Lens cover
C. Fluorescent lamp
A