- ページ 10

換気フード Whirlpool GZ7730XGS1のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool GZ7730XGS1 36 ページ。 30" (76.2 cm) and 36" (91.4 cm) slide-out vent range hood
Whirlpool GZ7730XGS1 にも：パーツリスト (4 ページ)

ページを印刷する

1. Installation Requirements

13. Place the vent hood on its back side on a protected surface.

a) Slide the screen forward.

b) Pull the tabs to remove the filters,

c) Remove the terminal box cover.

d} Close the screen.

e) Slide the mounting brackets to the top position.

A. Terminal box cover

NOTE: For some installations using the recirculating kit, it

may be easier to attach the vent system to the hood before

lifting the hood into its final position, Seal the connection with

clamps.

Lift the vent hood into its final position and feed the electrical

wire through the wiring opening in the range hood. The

mounting brackets should overlap the cabinet bottom or

wood filler strips. Center the range hood.

Check that the front panel is parallel with the cabinet front

when the screen is pushed in. Slide the screen forward.

Tighten the mounting bracket screws so that the vent hood is

secured to the cabinet.

....... i

........

A___

.....

A. Mounting bracket screw

B. Flat-blade screwdriver

Align the hood front panel with the cabinet. Slide the screen

forward. Locate the 2 screws on each side and turn them

counterclockwise

to loosen the screws. Adjust the front of the

vent vertically, %" (9.5 mm) up or down, or horizontally,

3/4"(19 mm) front to back, until the front is flush with the

cabinet. Tighten the screws. If it is necessary to adjust the

given dimensions, lower and add or remove the filler strips or

redrill mounting holes.

A. Phillips screwdriver

B. Adjustment

screws

A. Mounting bracket

B. Cabinet bottom

C. Optional wood filler strip

D. Vent hood

Electrical

Shock Hazard

Disconnect

power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical

shock.

1. Disconnect

power.

2. Connect the white wire of the power supply cable to the white

wire in the hood with a twist-on connector.