- ページ 10
換気フード Whirlpool IH7302RS0のPDF 取付説明書および取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool IH7302RS0 28 ページ。 30" (76.2 cm) wall-mount canopy range hood
ページを印刷する
RANGE HOOD USE
Operation
The canopy hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
Hood control panel
The hood controls are located on the underside of the canopy.
A
O I
A. Light switch
B. Blower switch
Operating the light
1. Move the light switch to the "1" position. The light should
turn on.
2. Move the light switch to the "0" position. The light should
turn off.
Operating the blower
1. Move the blower switch to the "1" position for low speed. "2"
position for medium speed. "3" position for high speed.
2. Move the blower switch to the "0" position. The blower
should turn off.
RANGE HOOD CARE
Be sure lights are cool before cleaning the hood.
Exterior surfaces
Clean the range hood with a mild detergent and soft cloth. Do not
use abrasive cleanser or steel wool pads.
Metal grease filters
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean.
Drain water through edge holes and let each filter dry thoroughly
before replacing it.
To remove metal filters:
1. Turn blower and lights off.
2. Push handle toward the rear and pull downward.
3. Pull filter toward the front.
10
B
O 1 2 3
Cleaning
To replace the metal grease filters:
4. Insert back edge of filter into rear channel of the filter opening.
5. Push handle toward the rear and push filter up.
6. Pull filter toward the front and insert into front channel.
Charcoal Filters - For non-vented (recirculating) installations
The charcoal filters are not washable or reusable.
They should be changed every 6 months in normal use.
The charcoal filters capture unpleasant cooking odors.
To install charcoal filters
1. Turn blower and lights off.
2. Remove the metal grease filters by pushing handle toward the
rear and pull downward.
3. Pull filter toward the front and set aside.
4. Repeat to remove other metal filter.
5. Install charcoal filter over grill on blower housing and turn filter
handle clockwise.
A
C
A. Blower housing
B. Handle
C. Charcoal filters
6. Repeat to install other charcoal filter.
To replace the metal grease filters:
7. Insert back edge of filter into rear channel of the filter opening.
8. Push handle toward the rear and push filter up.
9. Pull filter toward the front and insert into front channel.
To replace charcoal filters
1. Turn blower and lights off.
2. Remove the metal grease filters by pushing handle toward the
rear and pull downward.
3. Pull filter toward the front and set aside.
4. Repeat to remove other filter.
5. Turn charcoal filter handle counterclockwise.
6. Remove and discard charcoal filter.
7. Repeat to remove other charcoal filter.
8. Install replacement charcoal filter over grill in blower housing
and turn filter handle clockwise.
9. Repeat to install other charcoal filter.
To replace the metal grease filters:
10. Insert back edge of filter into rear channel of the filter opening.
11. Push handle toward the rear and push filter up.
12. Pull filter toward the front and insert into front channel.
B
C