- ページ 11

換気フード Whirlpool LI3Y5BのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool LI3Y5B 28 ページ。 30 inch (76.2 cm) range hood

ページを印刷する

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors

and odors from the cooktop area. For best results, start the

hood before cooking and allow it to operate several minutes

after the cooking is complete to clear all smoke and odors from

the kitchen.

The hood controls are located on the front panel on the right

side of the range hood.

A. Fluorescent lamp housing

B. Grease filter handle

C. Blower and light controls

D. Grease filter

Range Hood Controls

A. On/Off light button

B. Blower Off and speed minimum button

C. Blower speed medium button

D. Blower speed maximum button

Operating the light

The On/Off light button controls the light. Press once for On

and again for Off.

Operating the blower

The BLOWER SPEED buttons turn the blower on and control

the blower speed and sound level for quiet operation. The

speed can be changed anytime during fan operation by

pressing the desired blower speed button.

Press the BLOWER OFF button a second time to turn the

blower off.

RANGE HOOD CARE

Cleaning

IMPORTANT: Clean the hood and grease filters frequently

according to the following instructions. Replace grease filters

before operating hood.

Exterior Surfaces:

IMPORTANT: Do not use soap-filled scouring pads, abrasive

cleaners, Cooktop Polishing Creme, steel wool, gritty

washcloths or paper towels.

To avoid damage to the stainless steel, do not use cleaners that

contain chlorine.

Cleaning Method:

■ R ub in direction of grain to avoid scratching or damaging

the surface.

■ S tainless Steel Cleaner and Polish Part Number 31462A

(not included): See "Assistance or Service" section to order.

■ L iquid detergent or all-purpose cleaner:

Rinse with clean water and dry with soft, lint-free cloth.

■ G lass cleaner to remove fingerprints.

Metal Grease Filter

1. Remove each filter by pulling the spring release handle and

then pulling down the filter.

A. Spring release handle

2. Wash metal filters as needed in dishwasher or hot detergent

solution.

3. Reinstall the filter by making sure the spring release handles

are toward the front. Insert aluminum filter into upper track.

4. Push in spring release handle.

5. Push up on metal filter and release handle to latch into

place.

6. Repeat steps 1-5 for the other filter.

Replacing a Fluorescent Lamp

Turn off the range hood and allow the fluorescent lamp to cool.

1. Disconnect power.

2. Remove the screw from the lens cover and remove the

cover.

A. Screw

B. Lens cover

C. Fluorescent lamp

3. Remove the light from the socket and replace with a 120

volt, 13-watt (maximum), 50° fluorescent light for GX24

base.

4. Replace the lens cover and screw. Tighten the screw.

5. Reconnect power.

If new light does not operate, make sure the lamp is inserted

correctly before calling service.