- ページ 10

換気フード Whirlpool UXD8630DYSのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXD8630DYS 36 ページ。 30 76.2 cm and 36 91.4 cm retractable pop-up downdraft vent system
Whirlpool UXD8630DYS にも：取扱説明書 (44 ページ), 取付方法とお手入れ方法 (40 ページ)

ページを印刷する

4. Install the right and left undercounter mounting brackets to

the vent box. Slide the keyhole slots over the guide tabs and

push the brackets up to set them into place.

A. Vent box

B. Undercounter mounting bracket

C. Keyhole slots

D. Guide tabs

5. Attach the right and left end caps to the vent box. Place the

tab into the mounting slot at each end of the downdraft vent

as shown and push down to lock into place.

A. End cap tab

B. Mounting slot

6. Measure distance "X" from the cabinet floor to the top of the

countertop. Subtract 28¹⁄₂" from distance "X" to determine

dimension "Y" (X - 28¹⁄₂ = Y).

Downdraft vent

28¹⁄₂"

(73 cm)

Top of countertop

"X"

"Y"

Cabinet floor

7. Attach the support legs to the side of the vent box with

4 - 4 x 8 mm screws in each support leg. Adjust to dimension

"Y" from the bottom of the vent box to the bottom of the

support legs. Tighten screws.

A. Motor box

B. Support leg

C. 4 x 8 mm screws (4)

Determine Which Vent Direction Is Best For Your

Installation

When installed in a cabinet, vent system can exhaust through the

bottom, right or left of the cabinet.

IMPORTANT: When using the 6" (15.2 cm) vent transition

(supplied) for 6" round venting, only left or right venting is

recommended.

Bottom Venting:

NOTE: If installing the vent damper in the down position, a wall or

roof cap with a damper at the exit end of the vent system is

required.

Downdraft vent is shipped with blower in down venting

position so no modification is required.

If rear mounting of the blower motor is not required, go to

the "Complete Installation" section.

To mount the blower motor to the rear side of the vent

box, go to the "Rear Mounting - Blower Motor" section.

Dim. "Y"