- ページ 17

換気フード Whirlpool UXD8630DYSのPDF 取付方法とお手入れ方法をオンラインで閲覧またはダウンロードできます。Whirlpool UXD8630DYS 40 ページ。 30 76.2 cm and 36 91.4 cm retractable pop-up downdraft vent system
Whirlpool UXD8630DYS にも：取扱説明書 (36 ページ), 取扱説明書 (44 ページ)

ページを印刷する

The retractable downdraft vent system is designed to remove

smoke, cooking vapors, and odors from the cooktop area.

For best results, the vent should be operating before cooking

■

is started.

If you use large or tall utensils, place them on the large rear

■

element or burner surface.

A higher heat setting than normally used may be needed

■

when the downdraft vent is operating.

For gas cooktops, the downdraft vent system may affect

■

the flame stability and cooking performance. To improve

the burner performance, either decrease the downdraft vent

blower speed or increase the cooktop burner flame setting.

For gas cooktops with flame-sensing ignitions, the downdraft

■

vent system may disperse the flame away from the spark

igniter and may cause it to continually spark while trying to

reignite a burner that is already lit. To resolve the issue of the

cooktop igniter continuously sparking, either decrease the

downdraft vent blower speed or increase the cooktop flame

setting for that burner.

Surface of Downdraft Vent

To avoid damaging the finish, clean downdraft vent with soap

and water. Do not use scouring powder or abrasive solutions.

Exterior Surfaces:

To avoid damage to the exterior surface, do not use steel wool

or soap-filled scouring pads.

Always wipe dry to avoid water marks.

Cleaning Method:

Liquid detergent, soap and water or all-purpose cleanser.

■

Wipe with damp soft cloth or nonabrasive sponge, and then

■

rinse with clean water and wipe dry.

NOTE: To avoid damage, do not soak cloth or sponge.

Frequently remove and clean the filter(s) in the retractable section

of the downdraft vent. This will improve the operating efficiency of

the downdraft vent system.

To Replace:

1. Remove each filter by pulling the spring release handle and

then pulling down the filter.

2. Grease filters should be cleaned using warm water,

dishwashing liquid, and a non-abrasive brush.

3. Reinstall the filter by making sure the spring release handles

are toward the front. Insert metal grease filter into upper

track.

4. Pull the spring release handle down.

5. Push up on metal filter and release handle to latch into place.

6. Repeat steps 1-5 for the other filter.

VENT SYSTEM USE

VENT SYSTEM CARE

Filters

Operating Downdraft Vent

To Use:

1. Push and hold the button on top of downdraft vent for a few

seconds. (This slight delay helps avoid unintentional raising

of the vent during cleaning of the cooktop area.) Retractable

section of downdraft vent will rise. Blower will begin to vent

immediately if blower control knob slider is set to an On

position.

2. Slide the control slider on the right-hand side of the

downdraft vent to adjust the blower motor speed.

When Cooking Is Complete:

1. Push the button on top of the retractable downdraft vent.

The blower will turn off and the retractable section of the

vent will return to the closed position.

NOTE: If a spill occurs on the cooktop that allows liquids to

seep inside the downdraft vent, you must turn the downdraft

vent off immediately. It is possible to cause damage to the

downdraft vent if water is allowed inside the downdraft vent

while it is operating.

2. Immediately turn off the downdraft vent at the speed control

located on the right-hand side of the downdraft vent.

3. Turn off the power supply to the downdraft vent at the circuit

breaker box or fuse box.

4. Allow plenty of time for the downdraft vent to dry naturally.

Do not open the downdraft vent to remove the water.

To Clean:

1. Remove the filter(s) and clean using warm water,

dishwashing liquid, and a non-abrasive brush. The downdraft

vent will not operate when the filters are not in place.

2. Dry the clean filter(s) and reinstall, making sure that they lock

into place.

If Retractable Downdraft Vent Does Not Operate After

Clean Filters Have Been Installed:

Push the filter in as far as it will go. When the filter is removed,

the microswitch behind the filter is deactivated. This feature will

not allow the vent system to operate until the filter is properly

installed.

A. Spring-release handles

B. Left metal filter

C. Right metal filter