- ページ 6
換気フード Whirlpool UXG7480VDS0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXG7480VDS0 28 ページ。 30" (76.2cm), 36" (91.4cm) and 48" (121.9cm) wall-mount canopy grill vent hood installation instructions
• Ifthehouse h asaluminum w iring follow theprocedure below:
1. Connect asection o fsolid copper wire tothepigtail
leads.
2. Connect thealuminum w iring totheadded section o f
copper wire using special connectors and/or tools
designed andULlisted forjoining copper toaluminum.
Follow theelectrical connector manufacturer's
recommended
procedure. Aluminum/copper
connection must c onform with
local c odes and industry a ccepted wiring practices.
Wire sizes andconnections must c onform withtherating of
theappliance asspecified onthemodel/serial
rating plate.
The model/serial
plate islocated b ehind t hefilter ontherear
wall o fthehood.
Wire sizes must c onform totherequirements
oftheNational
Electrical Code, ANSI/NFPA
70(latest edition), orCSA
Standards C22.1-94, Canadian Electrical Code, Part 1 and
C22.2 No. 0 -M91 (latest edition) and alllocal c odes a nd
ordinances.
INSTALLATION INSTRUCTIONS
'
}ccs on
•
It is recommended
that the vent system be installed before
2. Pivot the back edge of the filter towards the back of the grill
hood is installed,
vent hood.
•
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
•
Check your ceiling height and the hood height maximum
before you select your hood.
1. Disconnect
power.
2. Determine which venting method to use: roof or wall.
3. Select a flat surface for assembling the grill vent hood. Place
covering over that surface.
Excessive Weight Hazard
Use two or more people to move and install grill
vent hood.
Failure to do so can result in back or other injury.
4. Using 2 or more people, lift grill vent hood onto covered
surface. Tip the hood on its back and remove filters and set
aside.
To Remove
Filters:
1. Using the filter handles, pull filter towards the front of the grill
vent hood.
B
<_
A
C
A. Filter handles
B. Front edge of filter
C. Back edge of filter
3. Drop the front edge of the filter down and remove.
Wood Mounting Strip Installation
1.
Determine and mark the centerline on the wall where the grill
vent hood will be installed.
Based on the ceiling or soffit height, determine the distance
"X" (30" [76.2 cm] min, 36" [91.4 cm] max) needed between
the cooking surface and the bottom of the grill vent hood. To
this distance, add 15%" (43.8 cm) and draw a horizontal line
(A) about 24" (61.0 cm) long centered on the vertical
centerline (B) at this distance for the wood mounting strip.
/
t
E\
A. Horizontal fine - mounting strip location
B. 15 _" (43.8 cm) - bottom of vent hood to
mounting strip location
C. Distance "X" (30" [76.2 cm] min, suggested
36" [91.4 cm] max) - cooking surface to
bottom of vent hood
D. Vertical centerline
E. Cooking surface
2. Locate and mark the wall studs along the horizontal line.
3. Center the 1" x 4" (2.5 x 10.2 cm) wood mounting strip above
the horizontal line.
6