- ページ 4
換気フード Whirlpool UXT2036AYW0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXT2036AYW0 28 ページ。 30" (76.2 cm) and 36" (91.4 cm) range hood
ページを印刷するINSTALLATION REQUIREMENTS
s csnd
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools needed
•
Drill
•
1¼" (3.0 cm) drill bit
•
1/8"(3.0 mm) drill bit for pilot holes
•
Pencil
•
Wire stripper or utility knife
•
Tape measure or ruler
•
Caulking gun and weatherproof
caulking compound
•
Flat-blade screwdriver
•
Phillips screwdriver
•
Saber or keyhole saw
•
Metal snips
•
Compass or 8" (20.3 cm) circle template
Parts Supplied
Remove parts from package. Check that all parts are included.
•
2 - 3.5 x 9.5 mm screws
•
7" (17.8 cm) round vent mounting plate
•
T-10 Torx _t adapter
•
T-20 Torx _t adapter
•
4- 4.5 x 13 mm mounting screws
Parts Needed
•
7" (17.8 cm) round metal vent system
•
Wall or roof cap with damper to match vent system
•
1 - 75W max, 120V incandescent
light bulb
•
3 - UL listed wire connectors
•
Vent clamps/duct
tape as required
For cabinets with recessed bottoms:
•
Two 2" (5.1 cm) wide filler strips. Length and thickness
determined
by recess dimensions.
•
Four flat head wood screws or machine screws with washers
and nuts (to attach filler strips).
IMPORTANT: Observe all governing codes and ordinances.
•
It is the installer's responsibility
to comply with installation
clearances specified on the model/serial rating plate. The
model/serial
rating plate is located inside the range hood on
the left wall.
Range hood location should be away from strong draft areas,
such as windows, doors and strong heating vents.
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance. Consult the
cooktop/range
manufacturer
installation instructions
before
making any cutouts.
Grounded electrical outlet is required. See "Electrical
Requirements"
section.
All openings in ceiling and wall where range hood will be
installed must be sealed.
These range hoods are factory set for vented installations.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured
Home Construction
Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction
and Safety, title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured
Home
Installation 1982 (Manufactured
Home Sites, Communities and
Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local
codes.
Product Dimensions
(2.2cm)
(16.7 cm}
(2.5cm)
(12.5 cm)
1-®TORX is a registered trademark
of Saturn Fasteners, Inc.