- ページ 6
換気フード Whirlpool UXT4030ADのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXT4030AD 24 ページ。 30" and 36" (76.2 and 91.4 cm) range hood
Whirlpool UXT4030AD にも： 取扱説明書 (28 ページ), 取扱説明書 (24 ページ), 取扱説明書 (24 ページ), 取扱説明書 (24 ページ)
ページを印刷する
5. Mark Hole Locations
Lift the range hood into place and insert the mounting bracket
tabs through the slots in the back of the range hood.
Hold the range hood firmly in place with one hand and bend each
mounting tab (A) upward approximately 90°.
Mark the hole at the power supply knockout (B).
OPTIONAL: Mark the hole in each mounting tab.
Remove the range hood and set it aside.
6
A
90˚
B
6. Drill Electrical Opening
Using a 1¹⁄₄" (3 cm) drill bit, drill the hole in the dot marked
previously at the electrical strain relief.
OPTIONAL: Using a ¹⁄₈" (3 mm) drill bit, drill pilot holes for the
dots marked previously at each mounting tab at an approximate
45° angle in an upward direction.
7. Prepare Range Hood Vents and
Mounting Tabs
A
Install Strain Relief
Install a UL Listed/CSA Approved ¹⁄₂" (13 mm) strain relief (A).
Mounting Tabs
Start a #8-18 x ⁵⁄₈" (4.2 x 16 mm) truss-head screw into the
mounting tab (C) on each side of the range hood as shown in
the inset. Insert the screws approximately 2 turns into the
mounting tab holes.
Non-vent (Recirculating) Installations
Remove the (2) T10
®†
Torx
rectangular vent cover (B).
†®TORX and T10 are registered trademarks of Acument Intellectual Properties, LLC.
C
x2
B
®
screws and remove the top, front