- ページ 5

換気フード Whirlpool UXT4030ADBのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXT4030ADB 24 ページ。 30" and 36" (76.2 and 91.4 cm) range hood

ページを印刷する

Installation Clearances

A. 24" (61 cm) minimum distance from electric cooking surface

24" (61 cm) minimum distance from gas cooking surface

30" (76.2 cm) suggested maximum above the cooking surface

B. 18" (45.7 cm) minimum clearance - upper cabinet to countertop

C. 30" (76.2 cm) minimum cabinet opening width for 30"

(76.2 cm) models and 36" (91.4 cm) minimum cabinet

width for 36" (91.4 cm) models

D. 12" (30.5 cm) cabinet depth

E. 36" (91.4 cm) base cabinet height

Venting Requirements

These range hoods are factory set for non-vented

(recirculating) installations and come with a charcoal filter.

See the "Assistance or Service" section for information

on ordering a charcoal filter kit, Part Number W10355450.

Electrical Requirements

Observe all governing codes and ordinances.

Ensure that the electrical installation is adequate and in

conformance with National Electrical Code, ANSI/NFPA

70 (latest edition) or CSA Standards C22.1-94, Canadian

Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edition),

and all local codes and ordinances.

If codes permit and a separate ground wire is used, it is

recommended that a qualified electrician determine that

the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

A 120 volt, 60 Hz., AC only, 15-amp, fused

■

electrical circuit is required.

If the house has aluminum wiring, follow

■

the procedure below:

1. Connect a section of solid copper wire

to the pigtail leads.

2. Connect the aluminum wiring to the added section

of copper wire using special connectors and/or tools

designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended

procedure. Aluminum/copper connection must conform

with local codes and industry accepted wiring practices.

Wire sizes and connections must conform with the rating

■

of the appliance as specified on the model/serial/rating

plate. The model/serial/rating plate is located inside the

range hood on the left wall.

Wire sizes must conform to the requirements of the National

■

Electrical Code, ANSI/NFPA 70 (latest edition) or CSA

Standards C22. 1-94, Canadian Electrical Code, Part 1

and C22.2 No. 0-M91 (latest edition), and all local codes

and ordinances.