- ページ 7

換気フード Whirlpool UXT4030AYのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXT4030AY 24 ページ。 30" (76.2 cm) and 36" (91.4 cm) range hood
Whirlpool UXT4030AY にも：取付説明書および取扱説明書 (32 ページ), 取扱説明書 (36 ページ)

ページを印刷する

Power Supply Cable Installation

1. For direct wire installations, run the home power supply cable

according to the National Electric Code or CSA standards

and local codes and ordinances. There must be enough

wiring from the fused disconnect (or circuit breaker) box to

make the connection in the hood electrical terminal box.

For optional power supply cord kit installations, follow the

instructions in the "Make Electrical Connections" section.

NOTES:

Do not reconnect power until the installation is complete.

Use only with range hood cord connection kits that have

been investigated and found acceptable for use with this

model range hood.

2. Remove the screw from the terminal box cover. Remove

terminal box cover and set aside.

A. Terminal box cover

B. Screw

3. Remove the power supply knockout from the top or rear of

the vent hood (depending on the incoming location of your

home power supply cable) and install a UL listed or CSA

approved ¹⁄₂" strain relief.

A. Power supply knockout

4. Using 2 or more people, lift the hood into final position. Feed

enough electrical wire through the ½" UL listed or CSA

approved strain relief to make connections in the terminal

box. Tighten the strain relief screws.

5. Position the range hood so that the large end of the keyhole

slots are over the mounting screws. Then push the hood

toward the wall so that the screws are in the neck of the slots.

Tighten the mounting screws, making sure the screws are in

the narrow neck of slots.

1. Disconnect power.

2. Use UL listed wire connectors and connect white wires (A)

3. Use UL listed wire connectors and connect black wires (B)

4. Connect green (or bare) ground wire from power supply to

5. Install terminal box cover.

6. Reconnect power.

Make Electrical Connection

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

A. White wires

B. Black wires

C. UL listed wire connector

D. Green (or bare) ground wire

together.

WARNING

Fire Hazard

Electrically ground the blower.

Use copper wire.

Connect ground wire to green ground screw in

terminal box.

Failure to do so can result in death, fire, or

electrical shock.

green ground screw in terminal box and securely tighten.

E. Home power supply cable or

power cord accessory kit

F. UL listed or CSA approved

½" strain relief

G. Green ground screw