- ページ 8

換気フード Whirlpool UXT4230ADB0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXT4230ADB0 28 ページ。 30" (76.2 cm) and 36" (91.4 cm) range hood

ページを印刷する

7. Drill Electrical

Opening

9. Attach

Vent Damper

or Transition

31/4 '' X 10" (8.3 X 25.4 cm) Rectangular

Vent Damper

Using a 11/4"(3 cm) drill bit, drill the hole in the dot marked

previously at the electrical strain relief.

OPTIONAL: Using a 1/8"(3 mm) drill bit, drill pilot holes for the

dots marked previously at each mounting tab at an approximate

45 ° angle in an upward direction.

8. Prepare

Range

Hood

Vents and

Mounting

Tabs

•

Install Strain Relief

Install a UL Listed/CSA Approved 1/2"(13 mm) strain relief (A).

•

Mounting

Tabs

Start a #8-18 x %" (4.2 x 16 ram) truss-head screw into the

mounting tab (F) on each side of the range hood as shown in

the inset. Insert the screws approximately

2 turns into the

mounting tab holes.

•

Non-vent

(Recirculating)

Installations

Remove the (2) T10 ®Torx ®screws and remove the top, front

rectangular vent cover (E). Go to Step 12.

•

31/4 '' x 10" (8.3 x 25.4 cm) Rectangular

Vent Installations

For top vent installations,

remove the top, rectangular vent

knockout (C).

For wall vent installations, remove the rear rectangular vent

knockout (B).

•

7" (17.8 cm) Round Vent Installations

Remove both top knockouts (C and D).

Using (2) short Phillips head screws, install the 31/4"x 10" (8.3

x 25.4 cm) rectangular damper over the top or rear vent

knockout removed in Step 8.

NOTE: If the wall cap used has a damper and it interferes

with the rectangular damper, remove the rectangular damper

flap.

7" (17.8 cm) Round Vent Mounting Plate

Using (2) short Phillips head screws, install the 7" (17.8 cm)

round vent mounting plate over the vent knockouts removed

in Step 8. Position the wide flange (C) to the front.

NOTE: An optional 7" (17.8 cm) round damper (A), Part

Number W10355451, and a 7" (17.8 cm) round vent mounting

plate (B), Part Number W10388168, are available as

accessories.

For information on ordering, see the "Assistance

or Service" section.

If installing the optional round damper, position it over the

round vent mounting plate.