- ページ 11

換気フード Whirlpool UXT4236AYW0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXT4236AYW0 36 ページ。 30" (76.2 cm) and 36" (91.4 cm) range hoods

ページを印刷する

NOTE: The 7" (17.8 cm) round vent mounting plate and

31/4 '' x 10" (8.3 x 25.4 cm) rectangular vent connector can

be installed up to 1" (2.5 cm) on either side of the hood

center to accommodate

off center ductwork.

A. Vertical connector

B. 6.5 x 9.5 mm screws

C. Vent knockouts

D. Horizontal connector

If a vent damper is installed with a wall cap with damper,

check to make sure they do not interfere with each other.

Remove the vent connector damper flap if they interfere.

Non-vented

(recirculating) installations - No vent

attachments.

The UXT42 and UXT52 series models

require the removal of the recirculation

cover plate.

Remove the two screws from the recirculation

cover plate

and remove.

Power Supply Cable Installation

1. For direct wire installations, run the home power supply cable

according to the National Electric Code or CSA standards

and local codes and ordinances. There must be enough

wiring from the fused disconnect

(or circuit breaker) box to

make the connection in the hood electrical terminal box.

For optional power supply cord kit installations, follow the

instructions

included with the power supply cord kit.

NOTE: Do not reconnect power until the installation is

complete.

2. Remove the screw from the terminal box cover. Remove

terminal box cover and set aside.

A. Terminal box cover

B. Screw

Remove the power supply knockout from the top or rear of

the vent hood (depending on the incoming location of your

home power supply cable) and install a UL listed or CSA

approved 1/2"strain relief.

A. Recirculation

cover plate

B. Screws

A. Power supply knockout

4. Using 2 or more people, lift the hood into final position. Feed

enough electrical wire through the 1/2" UL listed or CSA

approved strain relief to make connections

in the terminal

box. Tighten the strain relief screws.

5. Position the range hood so that the large end of the keyhole

slots are over the mounting screws. Then push the hood

toward the wall so that the screws are in the neck of the slots.

Tighten the mounting screws, making sure the screws are in

the narrow neck of slots.

6. Connect ventwork to hood. Seal joints with vent clamps or

duct tape to make secure and airtight.

7. Check that back draft dampers work properly.