- ページ 9

換気フード Whirlpool UXW7230BS0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXW7230BS0 32 ページ。 30" wall-mount canopy range hood

00_

Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

For non-vented (recirculating) installations only:

1. Assemble the air deflector with the duct cover bracket with

2 - assembly screws provided with the Recirculation

Kit.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

2. Remove the grease filter. See "Range Hood Care" section.

3. Level the range hood and tighten upper mounting screws.

4. Install 2 - 5 x 45 mm lower mounting screws and tighten.

1. Install transition on top of hood (if removed for shipping) with

2 - 3.5 x 9.5 mm sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over transition piece.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

A. Vent cover bracket

B. 2.9 x 6.5 mm screws

C. Deflector

Measure from the bottom of the air deflector to the bottom of

the hood outlet.

--A

...............

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

D. Vent duct

E. Exhaust outlet

3. Cut the duct to the measured size (X).

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over the exhaust

outlet from the hood.

7. Reassemble the air deflector to the duct cover bracket with

2 assembly screws.

8. Seal connections

with vent clamps.