- ページ 9

換気フード Whirlpool W10240582AのPDF 取付説明書および取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool W10240582A 28 ページ。 30" (76.2 cm) and 36" (91.4 cm) range hood

4. It is recommended that the blower assembly be removed to

make the range hood lighter and easier to install.

To remove:

Disconnect blower wiring plug.

A. Blower

B. Blower wiring plug

Loosen, but do not remove, knurled nuts on mounting

rods. Slip rods out of blower mounting brackets.

A. Mounting rod

B. Knurled nut

IMPORTANT: To avoid damage, do not grasp blower by

blower wheels.

Lift blower out and set aside.

5. Depending on your installation, remove either back or top

wiring knockout.

6. For vented installations:

Check that the louver cover is installed in front of hood.

Depending on your installation, remove either top or rear

rectangular vent knockout. If using round vent, remove

top rectangular knockout.

NOTE: Do not remove rectangular knockouts if

installation of range hood is to be non-venting

(recirculating).

If using rectangular vent, attach rectangular damper/vent

connectors to the range hood using 2 black sheet metal

screws.

A. Vertical vent

B. Black sheet metal screws

C. Hinge pin

D. Vent knockouts

E. Horizontal vent

If using round vent, attach vent transition piece

(purchased separately) to range hood top using 2 black

sheet metal screws.

NOTE: If the wall cap is directly behind the vent connector,

the dampers in the connector and wall cap must not interfere

with each other. Remove the vent connector damper if they

interfere.

7. Lift the range hood up under cabinet and determine final

location by centering beneath cabinet. Mark on the underside

of cabinet the location of the 4 keyhole mounting slots on the

range hood. Set range hood aside on a covered surface.

A. Keyhole slot

8. Use

" (3 mm) drill bit and drill 4 pilot holes as shown.

A. Drill pilot hole