- ページ 10

換気フード Whirlpool WVU57UC0FのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WVU57UC0F 36 ページ。 30" (76.2 cm) and 36" (91.4 cm) range hood
Whirlpool WVU57UC0F にも：取扱説明書 (36 ページ), 取扱説明書 (19 ページ)

ページを印刷する

Install Vent System

1. Install vent through the vent opening in upper cabinet or wall.

Complete venting system according to the selected venting

method. See the "Venting Requirements" section.

2. Use caulking to seal exterior wall or roof opening around

the cap.

Prepare Range Hood

Only for venting through the top/wall options:

1. Remove vent knockouts, depending on your installation

requirements.

A. Round vent knockout

B. Top rectangular vent knockout

C. Rear rectangular vent knockout

Round vent system installations - Remove top rectangular and

round vent knockouts.

Rectangular vent system installations - For roof installations,

remove the top rectangular vent knockout. For wall installations,

remove the rear rectangular vent knockout.

Non-vent (recirculating) installations - Do not remove any

knockouts.

2. Install 7" (17.8 cm) round vent mounting plate or 3¹⁄

(8.3 cm x 25.4 cm) vent damper, depending on your vent

system installation. Attach to range hood with 3.5 x 9.5 mm

screws provided and remove the tape from the damper flap.

NOTE: An optional 7" (17.8 cm) round damper is also

available as an accessory. For information on ordering,

see the "Accessories" section.

A. 7" (17.8 cm) round damper

(See the "Accessories" section)

B. 3.5 x 9.5 mm screws

C. 7" (17.8 cm) round vent mounting plate

D. Round vent knockout

E. Rectangular vent knockout

" x 10"

NOTE: The round vent damper may only be installed on the top

of the product.

A. Vertical air transition

B. 3.5 x 9.5 mm screws

C. Vent knockouts

D. Horizontal air transition

Only for recirculating options

For this venting method, it is neccesary to purchase a Charcoal

Filter Kit. See the "Accessories" section for ordering.

1. Remove each filter by pulling the spring-release handle and

then pulling down the filter.

2. Remove the venting method screw from the Vented option

with a T10 TORX

screwdriver and set aside.

A. Venting method screw