- ページ 8

換気フード Whirlpool WVW75UC6DSのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WVW75UC6DS 28 ページ。 36" (91.4 cm) island-mount canopy range hood
Whirlpool WVW75UC6DS にも：取扱説明書取付説明書 (28 ページ), 取扱説明書 (32 ページ)

ページを印刷する

Install In-Line Smart Kit - Optional

NOTE: Your range hood can work with either an internal or an

inline (external) blower motor system. An optional In-Line Smart

Kit (purchased separately) allows the blower motor that comes

with this range hood to be installed in a location other than

inside the range hood cavity.

CAUTION: To reduce the risk of fire and electric shock, install

this range hood only with the In-Line Smart Kit manufactured

by Whirlpool, Part Number W10692945.

For installation see the In-Line Smart Kit installation instructions.

See the "Assistance or Service" section to order.

Install Range Hood

1. Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

2. Remove the grease filter. See "Range Hood Care" section.

3. Level the range hood and tighten upper mounting screws.

4. Install (2) 5 x 45 mm lower mounting screws and tighten.

Use the optional wall anchors if needed.

Connect Vent System

1. Install transition on top of hood (if removed for shipping)

with (2) 3.5 x 9.5 mm sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over the exhaust outlet.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket

using (4) 4.2 x 8 mm screws.

2. Measure from the bottom of the air deflector to the bottom

of the hood outlet.

3. Cut the duct to the measured size "X."

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over

the exhaust outlet from the hood.

7. Reassemble the air deflector to the duct cover bracket

with the 4 assembly screws.

8. Seal connections with vent clamps.

A. Assembly screws

B. Air deflector

C. Duct cover bracket

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

D. Vent duct

E. Exhaust outlet