- ページ 2

スパ・アクセサリー Backyard Plus Lift ’n GlideのPDF 使用方法をオンラインで閲覧またはダウンロードできます。Backyard Plus Lift ’n Glide 3 ページ。 Retractable cover system

II.

Install hinge

1. Insert a #10 x 1½" screw through the second hole

(B) in the tube and into the hole on the side of the

cover as shown, and install but do not tighten.

2. Lift the tube so it is horizontal, and parallel with

the top of the cover. Drill a 1/8" hole (C) into the

side of the cover, through the hole in the tube

3. Install another #10 x 1½" screw and tighten.

Tighten first screw then drill the two remaining

holes (A, D) into the side of the cover using the

holes in the tube for locating.

4. Install two more #10 x 1½" screws and tighten.

5. Repeat this installation on the other side of the cover.

6. Adjust the position of the cover on the spa to ensure that it is

square, and centered on the spa.

7. Attach the main assembly to the spa side by sliding assembly

into closed position and raising it until it is horizontal with the

bottom of the spa cover as shown.

8. Install one #10 x 1½" screw in hole as shown and tighten.

9. Install five remaining #10 x 1½" screws.

10. Repeat procedure on opposite side.

III.

heck operation

View the position o

If your cover pushes the arms inward or outward when closed, you can

adjust them using the following procedure:

1. To adj

ust the arms first remove the safety cover, an

cover back so that lifter is fully extended, but do not open the

cover to the upright position.

Loosen and remove the bolt hi

the spacers from the left side of the tube to the right or vice

versa as necessary, in order to straighten the arm. Replace th

bearing, spacers, and bolt hinge pin before attempting to

operate.

Replace t

f the lifting arms. Arms are adjusted for standard setting.

nge pin and bearing, and move

he safety covers before use.

d slide the

Page 2