- ページ 5

安全装置 Firesense 64009のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Firesense 64009 6 ページ。 Round tempered glass wind guard for gas fire pits

ASSEMBLY

Carefully slide a Bottom Bracket

panel joint, with the cushioned foot pad pointed UP.

Align the edge of the metal Bracket with the edge of the two

glass panels, adjusted so the foot pad will hold the

assembled wind guard slightly off the table surface when

placed upright.

Verify that the bumper pad is in place at the tip of each

bracket set-screw. Do NOT tighten the screw directly to

the glass if the pad is missing. Check the carton for spare

pads, or contact Customer Service.

Check alignment, then carefully tighten set-screws until snug.

WARNING: over-tightening can break glass!

Install the remaining three Bottom Brackets in the same

manner.

Hardware Used:

Carefully (using two people if possible) turn the assembled

wind guard upright. Gently set the glass guard onto the fire

pit table, positioning the feet flat and level outside the

edges of the burner. Check that the bottom edges of the

glass panels are not directly touching the tabletop, and are

held off slightly by the foot pads of the lower brackets.

Ensure that the foot pads are not sitting directly on the fire

bowl.

Be aware that the glass and hardware may become warm

or hot after prolonged burning of the fire pit and take

reasonable precautions to avoid burns.

onto the top of each

Bottom Bracket x4