- ページ 2

コントロールユニット ABB OHDI-01のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ABB OHDI-01 11 ページ。 115/230 v digital input module
ABB OHDI-01 にも：ユーザーマニュアル (12 ページ)

Safety

WARNING! All electrical installation and maintenance work on the

drive should be carried out by qualified electricians only.

WARNING! The drive and adjoining equipment must be properly

grounded.

WARNING! Do not attempt any work on a powered drive. After

switching off the mains, always allow the intermediate circuit

capacitors 5 minutes to discharge before working on the drive, the

motor or the motor cable. It is good practice to check (with a

voltage indicating instrument) that the drive is in fact discharged

before beginning work.

WARNING! The motor cable terminals of the drive are at a

dangerously high voltage when mains power is applied,

regardless of motor operation.

WARNING! There can be dangerous voltages inside the drive from

external control circuits even when the drive mains power is shut

off. Exercise appropriate care when working on the unit.

Neglecting these instructions can cause physical injury or death.

There are two types of safety instructions throughout this manual:

• Notes draw attention to a particular condition or fact, or give

information on a subject.

• Warnings caution you about conditions which can result in serious

injury or death and/or damage to the equipment. They also tell you

how to avoid the danger. The warning symbols are used as follows:

Dangerous voltage warning warns of high voltage which can

cause physical injury and/or damage to the equipment.

Safety

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

115/230 VAC Digital Input Module – OHDI-01