- ページ 5

アクセサリー Caldwell Shootin' GalleryのPDF 組み立てと使用方法をオンラインで閲覧またはダウンロードできます。Caldwell Shootin' Gallery 8 ページ。 Motorized moving target system

STEP 3: Assembling the Back Cover

Assemble the Back Cover (986231) to the Legs as

shown in Photo H. If the holes are not aligned well,

loosen the lock nuts of Drive System or/and Motor

Cover and adjust Legs. You may also need to loosen

the bolts in the white block bushing. Insert two M6

Button Head Cap Screws into TOP HOLES ONLY

on the Back Cover and install two Lock Nuts. The bolts

in the lower holes will be installed in the next step.

Make sure the end of the long motor shaft is inside the

white block bushing as shown. Remember to

retighten any bolts you may have loosened.

PHOTO H

STEP 4: Assembling the Target

Impact Angle

Assemble the Target Impact Angle (165945) onto the

Back Cover as shown in Photo I. Fasten the Target

Impact Angle and Back Cover to the Legs by two M6

Flat Head Cap Screws (1000745) and M6 Lock Nuts

(1000743). Tighten the lock nuts.

PHOTO G

Double check that the end of

the long motor shaft is inside

the white block bushing

STEP 5: P-Clamp Assembly and

Wire Harness Routing

There are three P-clamps (1000750) to organize the

motor wires as shown in Photo J. Fasten the P-clamps

to the Motor Cover by three M6 Button Head Cap

Screws and M6 Lock Nuts.

IMPORTANT: Make sure the P-clamps are ori-

ented and wires routed as shown in Photo J, to

prevent potential failures.

PHOTO J

STEP 6: Assemble the Impact Plate

to the Front Wall

Fasten the Impact Plate (398741) to the Front Wall

(921568) by three M6 Carriage Bolts (1000746) and

M6 Lock Nuts (1000743). Tighten lock nuts. Photo K.

PHOTO K

Instructions continued on page 6. >>>>

PHOTO I

P-clamps