- ページ 12

ネットワーク・ハードウェア Firetide HotPort 6101のPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Firetide HotPort 6101 20 ページ。 6100 series
Firetide HotPort 6101 にも：クイック・インストール・マニュアル (2 ページ)

ページを印刷する

Connecting Cables

After your node is securely mounted, attach the two antennas, the

power cable, and any Ethernet cables you need, as shown in Figures

8 and 9.

Figure . Connected Outdoor Node

1 HotPort 6000 Series Mesh Nodes

Figure . HotPort Node Bottom Panel

Figure 10. Ethernet Cable for HotPort-HotPoint AP Connection

If you are using your Series 6200 with a companion Firetide Hot-

Point access point, a special Ethernet cable is available to connect

the two units and to supply PoE power to the AP. The cable is shown

in Figure 10.

Note the locations of the reset button under the weatherproof cap,

just below Ethernet port 3. To perform a factory reset on the unit,

power it on and wait for the status light to come on. Then press the

reset button.

February 2007