- ページ 11
ネットワーク・ハードウェア 3Com AirProtect Enterprise Engine 6100のPDF クイック・セットアップ・マニュアルをオンラインで閲覧またはダウンロードできます。3Com AirProtect Enterprise Engine 6100 14 ページ。 Secure converged networks enterprise edition
3Com AirProtect Enterprise Engine 6100 にも： 製品マニュアル (15 ページ), クイック・セットアップ・マニュアル (12 ページ)
ページを印刷する
Step 9: Connect 3Com AirProtect Sensors to the Network
Power and Connect to the Network
A. Ensure that the 3Com AirProtect Enterprise Server is already running on your network.
Note: Make sure that a DNS entry 'wifi‐security‐server' is set up on all DNS Servers. This entry should
point to the IP address of the Server. Otherwise, configure the Sensor manually. Please refer to the 3Com
AirProtect Enterprise Installation Guide for details.
B.
Use network interface cables to connect 3Com AirProtect Sensors to all the network segments
(subnets) that need to be protected. Make sure that the network segment is DHCP enabled.
Otherwise, configure the IP address of the 3Com AirProtect Sensor manually.
Note: Log in to the Server using SSH. Run the command 'get sensor list' to check if all the Sensors added
have been detected by the Server. If all the Sensors are connected, go to the next step. If some Sensors are not
connected, then you may need to configure the Sensors manually.
C. Wait for the status of the LEDs to stabilize. This process may take up to 2 minutes.
D. If all LEDs glow green, then the 3Com AirProtect Sensor is operational and connected to the
3Com AirProtect Enterprise Server.
E.
If Step D succeeds, the Sensor is now fully operational and is ready to protect your network.
LED1
LED2
Solid Green
Solid Green
3Com AirProtect Enterprise Quick Setup Guide
LED3
LED4
Solid Green
Solid Green
9