- ページ 6

ラック＆スタンド Ergo EMPRO-WM175BのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Ergo EMPRO-WM175B 13 ページ。 Flat panel swing out arm

Small Straw

or Toothpick

Marking the 1/8"

Allowance

Small Straw or Toothpick

Depth Plus 1/8" Allowance

Small Straw

Depth Plus 1/8" Allowance

Mark

or Toothpick

Mark

Determining the Mounting Hardware

Insert a small straw or toothpick into the threaded

inserts found on the back of the fl at panel.

Use a pencil to mark the depth of the threaded

insert on the small straw or toothpick.

Mark the straw or toothpick 1/8" above the depth of

the threaded insert, as shown in Figure 1.

Insert the small straw or toothpick into the

remaining threaded inserts to compare and verify

their depth using the straw or toothpick's 1/8"

allowance mark.

Locate the correct diameter screw for the threaded

insert.

If the screw you selected is longer than the 1/8"

allowance mark on the small straw or toothpick, as

shown in fi gure 2 and fi gure 3, do not use this screw.

The screw length must not bypass the mark.

Test each size of the screws provided.

The correct screws should thread easily into the

mounting point and not pull out when tension is

applied.

NB. You must account for the bracket, spacers and

Griplate™ depths when using the Thread Depth

Indicator to measure the thread depth of your fl at

panel.

Universal Spacers Installation

If your fl at panel has uneven mounting points, or

recessed mounting points, please use the provided

universal spacers.

The universal spacer may be stacked six high, for a

total stacking height of 1-1/2". The universal spacers

must be stacked in the direction shown above.

The universal spacers must be placed between the

mounting bracket and the fl at panel. The universal

spacer will fi t M4, M5, M6 and M8 screw sizes.