- ページ 4

カーアラーム Clarion G1100のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Clarion G1100 15 ページ。 Vehicle security system

Wiring Description

14-Pin Main Harness

Pin 1 - Red: Main Power (+12v) input [15A fuse]

Connect to constant +12v. A clean source of power is essential. This connection can be made at either the battery or at

the constant power supply wire to the ignition switch.

If this wire needs to be lengthened, use the appropriate wire gauge to avoid a drop in current and be sure to install a fuse

near the connection. Do not remove or bypass the fuse holder included on the wire harness.

Pin 2 - Brown: Siren (+12v) output.

Connect to the Red siren wire. Connect the Black siren wire to chassis ground.

Pin 3 - White: Parking Light (+12v) output.

Connect to positive light circuit. For vehicles that have independent left and right parking light circuits, the parking light

wires must be connected using diodes to keep the circuits separate.

Pin 4 - * Blank *

Pin 5 - * Blank *

Pin 6 - Brown/White: Horn Honk (-) output.

Connect to a relay to honk the vehicle horn.

Pin 7 - Orange: Optional Circuit Defeat (-) output.

Provides a negative output to disable the vehicle's starter circuit. Connect to an optional relay as shown

Pin 8 - Blue: Hood/Trunk Trigger (-) input.

Connect to a negative output from the hood and trunk pin switches.

Pin 9 - * Blank *

Pin 10 - Yellow/White: Auxiliary (-) output.

Provides a negative (-) momentary output.

Pin 11 - Yellow: Ignition input (+12v) input.

Connect to a source that maintains +12v when the ignition key is in both the "on" and "start" positions.

Pin 12 - Black: Ground.

Connect to a solid chassis ground. Be sure to use a ring connector of proper size. Scrape away the paint at the grounding

point.

Pin 13 - Violet: Door Trigger (+12v) input

Connect to positive door switch circuit. This circuit, commonly found in Ford vehicles, will show (+12v) when the door is

open.

Pin 14 - Green: Door Trigger (-) input

Connect to negative door switch circuit. This circuit will show (-) when the door is open.

3-Pin Door Lock Harness

Pin 1 - Green: (-) output

Pin 2 - Red: Not used

Pin 3 - Blue: (-) output

Page 3 - G1100 Installation Manual

(See Door Lock Diagrams - Page 14)