- ページ 4
カーアラーム Clarion UNGO PRO SECURITY K20のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Clarion UNGO PRO SECURITY K20 14 ページ。 Clarion k20 cctv systems: installation guide
Clarion UNGO PRO SECURITY K20 にも： オーナーズマニュアル (19 ページ)
ページを印刷する
Primary Harness (H1), 18-pin connector
___
RED
H1/1
___
BLUE
H1/2
___
BLACK/WHITE-1
H1/3
___
BLACK/WHITE
H1/4
___
GREEN/BLACK
H1/5
___
WHITE/BLACK
H1/6
___
VIOLET/BLACK
H1/7
___
BLUE/BLACK
H1/8
___
VIOLET
H1/9
___
WHITE
H1/10
___
BLACK
H1/11
___
BROWN
H1/12
___
LT. GREEN/BLACK
H1/13
___
WHITE/BLUE
H1/14
___
YELLOW
H1/15
___
ORANGE
H1/16
___
BROWN/BLACK
H1/17
___
RED/WHITE
H1/18
H1/1 RED (+)12V Constant Power Input
Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or the constant 12V supply to the ignition switch.
NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the fuse in the harness for this purpose. This fuse pro-
tects the module itself.
H1/2 BLUE (-) 200 mA Second Unlock Output
The H1/2 BLUE output is used for progressive unlock. A progressive unlock system unlocks the driver's door when the unlock (disarm) button
is pressed and unlocks the passenger doors if the unlock (disarm) button is pressed again within 15 seconds after unlocking the driver's door. The
BLUE wire outputs a low current (-) pulse on the second press of the unlock button of the transmitter. This negative unlock output is used to
unlock the passenger doors.
H1/3 BLACK/WHITE-1 Domelight Supervision Input
This wire determines what the output polarity of H1/4 will be. If the door pin circuit is negative, connect to chassis ground. If the door circuit
is positive, connect to a fused 12V source.
H1/4 BLACK/WHITE Domelight Supervision Output
Connect this wire directly to the domelight circuit in the vehicle. The on-board relay will drive circuits up to 30 amperes. The polarity of this
output is determined by the connection of the input wire H1/3 in the Relay Harness.
NOTE: If the input wire H1/3 is not connected, there will be no output on this wire.
4
(+) 12V CONSTANT POWER INPUT
(-) 200 mA SECOND UNLOCK OUTPUT
INPUT OF DOMELIGHT SUPERVISION RELAY #87
OUTPUT OF DOMELIGHT SUPERVISION RELAY #30
LOCK #30 COMMON OUTPUT
LOCK #87 NORMALLY CLOSED
LOCK #87 NORMALLY OPEN (INPUT)
UNLOCK #30 COMMON (OUTPUT)
UNLOCK #87 NORMALLY OPEN (INPUT)
(+/-) PARKING LIGHT FLASH OUTPUT
(-) CHASSIS GROUND INPUT
(-) 200 mA CHANNEL 3 VALIDITY OUTPUT
(+) SWITCHED IGNITION INPUT (ACCESSORY)
(-) 500 mA GROUND-WHEN-ARMED OUTPUT
UNLOCK #87A NORMALLY CLOSED
IMPORTANT! The H1/3 wire is not required for wiring the door locks. Depending on
the type of door lock system, there may be additional wires for the Door Lock wiring
that are not required.
(-) HORN HONK OUTPUT
FACTORY ALARM DISARM
(-) OUTPUT OF CHANNEL 2