- ページ 12

計測機器 Caleffi solar iSolar Wmz-G1のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Caleffi solar iSolar Wmz-G1 16 ページ。

ページを印刷する

VBus

adjustments

Adj. values:

VBus

Subaddress

Bus mode

Adj. values:

Subaddress

Bus mode

Bus master

6. Reports

Reports:

back

Everything OK

Version

active

If subaddress "0" and bus mode "Cascaded" are selected,

adjustments for the bus master have to be made:

•

cascaded

yes

VBus

adjustments.

• Subaddress:

Î Adjust a subaddress for a iSolar WMZ-G1

An individual module address can be adjusted for a

WMZ-G1. This way, it is possible to use several WMZ-G1

with individual addresses in one system. If several

WMZ-G1 (up to 16 in total are possible) are connected

to one PC or datalogger, the WMZ-G1 have to be num-

bered serially, starting with 0. The connection sequence

at the VBus

-connection is arbitrary.

Adjustment range: 0 ... 15.

•

Bus mode:

Adjust the bus mode

Do not change the factory setting if the WMZ-G1 is

connected to a controller with VBus

(corresponds to the bus mode "Passive").

Select bus mode "Active", if the WMZ is not connected

to a controller and if data are recorded on a PC or

datalogger.

Select bus mode "Cascaded", if several WMZ are con-

nected to a PC or datalogger. The WMZ modules are

serially numbered starting with 0 (see above).

Adjustment range: Active, Passive, Cascaded.

Bus master:

Adjust the bus master

Select bus master "No" when several WMZ-G1 modules

are cascaded and used along with a controller.

Select bus master "Yes" when several WMZ-G1 modules

are cascaded and used without a controller.

Note:

For detailed examples of connection see chap-

ter 7 on page 15 of this manual.

In the submenu "Reports" different messages are indicated.

During normal operation, the messages to the left are

displayed.

Note:

Error messages depend on the error and on the

sensor type selected previously!

output terminal