- ページ 5

プリンター Xerox 8560DN - Phaser Color Solid Ink PrinterのPDF 補足マニュアルをオンラインで閲覧またはダウンロードできます。Xerox 8560DN - Phaser Color Solid Ink Printer 26 ページ。 Phaser 8560 series
Xerox 8560DN - Phaser Color Solid Ink Printer にも：補足マニュアル (10 ページ), クイック・ユース・マニュアル (5 ページ), ボラティリティの手紙 (1 ページ), インストレーション・マニュアル (2 ページ), インストラクションシート (2 ページ), 評価者マニュアル (20 ページ)

2. Close the document feeder.

3. On the control panel, select

calibration page.

4. Wait for the scan to be completed, and then select one of the following options:

■

If the control panel indicates

■

If the control panel indicates

5. Remove the Scanner Calibration page from the document glass.

■

If you have a document feeder, continue with the steps in the Document Feeder section.

■

If you have a document glass cover, you have completed scanner calibration.

Document Feeder

1. Place the Scanner Calibration page in the document feeder, so that the top edge of the page enters the

feeder first. Adjust the paper guides to fit against the page.

Note: Make sure the Scanner Calibration page is aligned correctly and the paper guides are adjusted to

fit against the paper. If the page is misaligned, the calibration procedure will fail.

2. On the control panel, select

calibration page.

3. Wait for the scan to be completed, and then select one of the following options:

■

If the control panel indicates

complete.

■

If the control panel indicates

Note: For more information about calibrating the scanner, see the Knowledge Base at

www.xerox.com/office/8510_8560support.

, and then press the OK button to scan the

Document Glass Step

, press the OK button, and then continue with Step 5.

Success

, press the OK button, and then repeat Steps 1–4.

Failure

Document Feeder Step

, press the OK button. The calibration procedure is

Success

, press the OK button, and then repeat Steps 1–3.

Failure

, and then press the OK button to scan the

www.xerox.com/office/8510_8560support

2 of 2

LTR/LGL

075-1018-00 Rev A