- ページ 8

プリンター Xerox B230のPDF リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Xerox B230 28 ページ。
Xerox B230 にも：クイック・リファレンス・マニュアル (8 ページ)

ページを印刷する

Safety

CAUTION—POTENTIAL INJURY:

personal injury or printer damage:

• Make sure that all doors and trays are closed.

• Turn off the printer, and then unplug the power cord from the electrical outlet.

• Disconnect all cords and cables from the printer.

• If the printer has separate floor-standing optional trays or output options attached to it,

then disconnect them before moving the printer.

• If the printer has a caster base, then carefully roll it to the new location. Use caution when

passing over thresholds and breaks in flooring.

• If the printer does not have a caster base but is configured with optional trays or output

options, then remove the output options and lift the printer off the trays. Do not try to lift

the printer and any options at the same time.

• Always use the handholds on the printer to lift it.

• Any cart used to move the printer must have a surface able to support the full footprint of

the printer.

• Any cart used to move the hardware options must have a surface able to support the

dimensions of the options.

• Keep the printer in an upright position.

• Avoid severe jarring movements.

• Make sure that your fingers are not under the printer when you set it down.

• Make sure that there is adequate clearance around the printer.

CAUTION—HOT SURFACE:

from a hot component, allow the surface to cool before touching it.

CAUTION—PINCH HAZARD:

with this label. Pinch injuries may occur around moving parts, such as gears, doors, trays, and

covers.

CAUTION—MOVING PARTS:

parts.

CAUTION—POTENTIAL INJURY:

performance of procedures other than those specified in the User Guide may result in

hazardous radiation exposure.

CAUTION—POTENTIAL INJURY:

replaced. There is a danger of explosion if a lithium battery is incorrectly replaced. Do not

recharge, disassemble, or incinerate a lithium battery. Discard used lithium batteries according

to the manufacturer instructions and local regulations.

This product is designed, tested, and approved to meet strict global safety standards with the use of

specific manufacturer components. The safety features of some parts may not always be obvious.

The manufacturer is not responsible for the use of other replacement parts.

Refer service or repairs, other than those described in the user documentation, to a service

representative.

Xerox

B230 Printer

Safety, Regulatory, Recycling, and Disposal Reference Guide

When moving the printer, follow these guidelines to avoid

The inside of the printer might be hot. To reduce the risk of injury

To avoid the risk of a pinch injury, use caution in areas marked

Indicates a risk of laceration or abrasion injuries from rotating

This product uses a laser. Use of controls or adjustments or

The lithium battery in this product is not intended to be