プリンター Xerox DocuColor ServerのPDF リリースノートをオンラインで閲覧またはダウンロードできます。Xerox DocuColor Server 6 ページ。

DocuColor

Color Server

Customer Release Notes

DocuColor Server, system software version 1.0

for Xerox digital copier printers

These notes contain information about the DocuColor Server that was not available when

the customer documentation was printed. Prior to using the DocuColor, please read these

release notes and distribute them to all DocuColor users.

Write your support phone number here for reference.

Power cycling the DocuColor

When you power on, you should ﬁrst turn on the copier and then turn on the DocuColor.

If you need to power cycle (power off and then back on) either the copier or the

DocuColor, make sure that the DocuColor is either Idle or ﬂashing red.

After power cycling the DocuColor several times, the System Time and System Date may

be incorrect. Reset them in Control Panel Setup.

Terminating the DocuColor

You must use the terminator included with your DocuColor as follows:

• If the DocuColor is not connected to a CD-ROM drive, terminate the SCSI port on the

server.

• If there is a CD-ROM drive connected to the DocuColor, terminate the open SCSI port

on the CD-ROM drive.

Control Panel Setup

The ﬁrst time you set up the DocuColor from the Control Panel, you must do Server,

Network, and Printer Setup in that order. If you later change information in one of the

Setups, you must open the other Setup menus to make sure that changes take effect

properly—even if you do not need to change any settings.

Language Setup

If you want to change the language in which messages appear after your initial language

selection, you must reinstall system software.

Messages on the Control Panel appear in English until you select a language. In addition,

no matter what language you select, messages and menus for the Format Disk and Install

Software commands always appear in English.

Unexpected printing results

Corrupted job ﬁles sent to the DocuColor may cause unexpected printing results. If this

happens, power cycle the DocuColor. If problems persist, use the Clear Server command

from the Control Panel. See the User Guide for details.

Part number: 10016501