- ページ 6

Dynamic Methods of Setting the System's IP Address

You can set the system's IP address using any of the following methods.

■

DHCP

CentreWare IS

■

AutoIP

Information Required for Manual IP Addressing

Information

Internet Protocol (IP) address of the system

Network Mask

Default Router/Gateway address

Enabling DHCP on the System

Verify that the system DHCP protocol is enabled by setting the control panel or by using

CentreWare IS.

Note

To determine the system's IP address, select

For information about the control panel, see the Features section of this guide.

Changing or Modifying the IP Address Using CentreWare IS

CentreWare IS provides a simple interface that enables you to manage, configure, and monitor

networked systems from your desktop using an embedded web server. For complete

information about CentreWare IS, click the Help button in CentreWare IS to go to the

CentreWare IS Online Help.

After setting the system's IP address, you can modify TCP/IP settings using CentreWare IS.

Launch your web browser.

Enter the system's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).

Select Properties.

Select the Protocols folder on the left sidebar.

Select TCP/IP.

Enter or modify the settings, then click Save Changes at the bottom of the page.

Connections and Internet Protocol (TCP/IP)

Comments

Format is xxx.xxx.xxx.xxx, where xxx represents

a decimal number from 0–255.

If you are unsure, leave this blank; the system

chooses an appropriate mask.

Router address is required to communicate with

the host device from anywhere other than the

local network segment.

System Identification

WorkCentre® C2424 Copier-Printer

6-6

at the control panel.