- ページ 8

電動工具 Direct power DPB053STMのPDF 安全および操作マニュアルをオンラインで閲覧またはダウンロードできます。Direct power DPB053STM 17 ページ。 2000w wallpaper stripper

Fig 1

Fig 2

TWS200-M-070924.indd 8

Note: Before using the tool, read the

instruction book carefully.

ASSEMBLY

Note:

Remove the plug from the socket

before carrying out adjustment, servicing or

maintenance.

1. Attaching the steam plate hose (Fig 1)

Take care when attaching the connect pipe (6) to

the steam plate (8) and the unit as the threads are

plastic. Do not cross the threads,as this will cause

damage.

OPERATION & USE

1. Filling the water tank

Warning:There is a danger of scalding.You

must never attempt to remove the safety cap

while the unit is switched on or under pressure.

The tools and hose get hot during use. Allow the

tools to cool down before changing them while

the steamer is being used.

The water tank has a capacity of 4.5 liters. Fill the

tank as follows:

1. Check that the mains supply is disconnected.

2 .Unscrew the safety cap3. (Fig 2)

3. Make sure that the water tank is on a stable ﬂat

surface.

4. Pour water, preferably hot, into the water tank.

Distilled water is not necessary.

5. Fill the water tank to the MAX level (5) for the

longest steaming time. For a shorter steaming

time use less water, but do not ﬁll to less than the

MIN level.

Warning: Do not overﬁll the water tank.

Fill to the MAX level5. Never put descaling,

aromatic, alcoholic or detergent products into

the water tank, as this may damage it or make it

unsafe for use.

6. Screw the safety cap back onto the water tank

and tighten by hand.

7 . Connect the hose to the water tank by screwing

the captive nut on the hose in a clockwise direction

until it is tight.

2007-9-25 15:45:02