- ページ 13

コピー機 Xerox Regal 5790のPDF リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Xerox Regal 5790 44 ページ。 Digital color copier/printer materials usage guide
Xerox Regal 5790 にも：補足マニュアル (1 ページ), リファレンス・マニュアル (7 ページ), リファレンス・マニュアル (7 ページ), スタートマニュアル (46 ページ), リファレンス・マニュアル (18 ページ), 仕様 (7 ページ)

ページを印刷する

REGAL 5790 MATERIALS USAGE GUIDE

Tray Bypass. Next, open the front door and turn knobs A, B and

C in the direction shown by the arrows. Finally, pull the Transfer

Drawer out carefully to clear the jam.

CAUTION: Forcing the Transfer Drawer open may cause machine

damage resulting in a service call.

CAUTION: The use of paper weights greater than 90 lb Index (163

gsm) is likely to result in damage to the copier/printer that will

require a service call. Do not exceed the maximum recommended

paper weights, except where noted (Jupiter Thinplate 7 pt.).

Hints, Tips & Testing Results

Extensive Xerox testing has shown the following:

•

When the recommended materials are run as detailed above,

with the correct tray, mode, orientation and curl, feeding

performance is good, but will not equal 24 lb LX performance.

•

Image quality on the recommended papers is good, but should

not be expected to equal image quality on 24 lb LX paper. The

rough formation of heavy papers increases the likelihood of

image mottle (light patches) with some images. Mottle is more

likely to occur on images with uniform halftone areas. As

humidity increases, mottle usually increases.

•

A small percentage of sheets may exhibit toner on the lead

edge. Flipping the paper over or manually curling the lead edge

down will minimize this condition.

•

Two-sided copying of heavy-weight papers is not

recommended. Paper curl created when running side 1 can

cause a high jam rate with side 2. If this occurs, flipping the

paper over for side 1 may improve curl and feeding

performance. Manually curling the lead edge of the side 1

imaged sheets down before loading them for side 2 can also

improve side 2 feeding reliability. Image quality on side 2 will

also be reduced with certain images. Light image patches

(mottle) and deletions are likely on side 2, especially in large

halftone areas.

•

Toner saturation on electronic originals should be limited to a

total of 280% (70% for each Color). Higher toner saturation can

result in poorly fused prints.

•

Jupiter Thinplate 7 pt. (181 gsm) has been tested and has

shown improved image quality. Due to its increased weight,

more frequent jams should be expected. It is especially

important to load Jupiter 7 pt. curl down. It may be necessary to

allow the paper to acclimate to the environment before its

natural curl can be determined. As with all 17" heavy-weight

papers, only 17 x 11" short-grain Jupiter 7 pt. can be run.

Jupiter 7 pt. is distributed by Kirk Paper Company in the USA

(714) 978-1619.

USAGE GUIDELINES