- ページ 5

サンダー Direct power BP245のPDF 安全および操作マニュアルをオンラインで閲覧またはダウンロードできます。Direct power BP245 13 ページ。 120w car buffer/polisher

- Work with approved safety equipment, such as those dust masks that are specially

designed to ﬁlter microscopic particles.

ADDITIONAL SAFETY RULES FOR YOUR CAR POLISHER

1. Check that speed marked on the label is equal to or greater than the rated speed of

the polisher.

2. Inspect the sponge pad before use. Do not use chipped, cracked or otherwise

defective products.

3. Ensure that the bonnets are ﬁtted in accordance with the manufacturer's

instructions.

4. Ensure that the bonnet is correctly mounted and tightened before use and run

the tool at no-load for 30 seconds in a safe position. Stop immediately if there is

considerable vibration or if other defects are detected. If this condition occurs,

check the machine to determine the cause.

5. For cleaning, personal protective equipment such as gloves and apron should be

worn.

6. The wheel continues to rotate after the tool is switched off.

7. Do not use the polisher as a ﬁxed tool.

8. Always use the appropriate safety equipment that is required for the product.

e.g. Goggles / Safety Spectacles, Ear defenders (essential with tools with a noise

rating of over 85 dbA), Gloves and face masks. In all cases ensure that the safety

equipment is in good condition.

Double insulation:

The tool is double insulated.This means that all the external metal parts are electrically

insulated from the mains power supply.This is done by placing insulation barriers

between the electrical and mechanical components making it unnecessary for the tool

to be earthed.

Important note:

Remove the main plug from socket before carrying out any adjustment or servicing.

Ensure your mains supply voltage is the same as your tool rating plate voltage.

SYMBOLS

Read the manual

Wear dust mask,eye & ear protection

Conforms to relevant safety standards

120W CAR BUFFER/POLISHER

Warning

Wear gloves

BP245