- ページ 6
プリンターアクセサリー Xerox STACKER 8855/721PのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Xerox STACKER 8855/721P 11 ページ。 Wide format solutions - stacker
ページを印刷する
Safety Notes
Your stacker has been designed and tested to meet strict safety requirements. These include safety agency examination and approval, and
compliance to established environmental standards. Please read the following instructions carefully before operating the Stacker.
NOTE: Refer to Instructions as needed to ensure the continued safe operation of your stacker.
FOLLOW all warnings and instructions marked on or supplied with the product.
UNPLUG the stacker from the wall outlet before cleaning. Always
use materials supplied or approved by Xerox. Use of other materials
may result in poor performance and could create a hazardous
situation.
DO NOT use aerosol cleaners
NEVER use supplies or cleaning materials for purposes other than
what they were intended. Keep all supplies and materials out of
reach of children.
DO NOT use the stacker near water, wet locations, or outdoors.
This copier must be grounded.
THIS PRODUCT is equipped with a 3-wire grounding-type plug (i.e.,
a plug having a third grounding pin) and an additional safety device.
This plug will only fit into a grounding-type power outlet. This is a
safety feature. To avoid risk of electric shock, contact your
electrician to replace the receptacle if you are unable to insert the
plug into the outlet. Never use a ground adapter plug to connect the
copier to a power source receptacle that lacks a ground connection
terminal.
THIS STACKER should be operated from the type of power source
indicated on the marking label. If you are not sure of the type of
power available, consult your local power company.
WARNING
IF AN EXTENSION CORD is used with this stacker, ensure that the
total of the ampere ratings of the products plugged into the extension
cord does not exceed the extension cord ampere rating. Also, make
sure that the total amperage of all products plugged into the wall
outlet does not exceed the outlet protection.
DO NOT install the stacker in direct sunlight, a high humidity or dusty
environment.
DO NOT install the stacker where the floor or base is unstable. The
stacker may fall, causing personal injury and/or serious damage to
the stacker.
NEVER spill liquid of any kind on the stacker.
DO NOT allow anything to rest on the power cord. Do not locate this
stacker where people will step on the cord.
NEVER remove any covers or guards that require a tool for removal.
There are no operator-serviceable areas within these covers.
THE POWER SUPPLY CORD is the disconnect device for this
stacker. Ensure that installation is near the outlet and is easily
accessible.
NEVER attempt any function that is not specified in this User Guide
or directed by an authorized Xerox representative.
4