- ページ 2

プリンターアクセサリー Xerox VersaLink B7030のPDF メンテナンスをオンラインで閲覧またはダウンロードできます。Xerox VersaLink B7030 5 ページ。 Drum cartridge
Xerox VersaLink B7030 にも：クイック・ユース・マニュアル (20 ページ), マニュアル (6 ページ), クイック・スタート・マニュアル (2 ページ), クイック・ユース・マニュアル (20 ページ), セキュリティ機能補足マニュアル (50 ページ), クイック・ユース・マニュアル (20 ページ)

WARNING: Never throw drum cartridges into heat or flame. Never touch a labeled area on or near

the heat roller in the fuser, you may be burned. If a sheet of paper wraps around the heat roller, do

not try to remove it immediately. Turn off the printer and wait 40 minutes for the fuser to cool. Try

to remove the jam after the printer has cooled.

Solution: Clean the Printhead Lens

The print head LED lens requires regular cleaning to maintain print quality. Clean the print head LED

lens every time the drum cartridge is replaced or if print quality starts to degrade.

1. Remove, then replace the drum cartridge.

2. Remove the print head LED lens-cleaning rod from inside the front door.

3. Slowly push the cleaning rod into the printer until it stops, then pull it out. Repeat this action two

more times.

4. Return the cleaning rod to its original location and close the front door.

Solution: Empty the Hole Punch Waste Container. When the hole-punch waste container is full, a

message appears on the touch panel.

1. Lift the finisher transport top cover, then open the front transport cover.

2. Pull out the hole-punch waste container. EMPTY COMPLETELY.

4. Insert the container, then slide it all the way into the finisher.

5. Close the finisher front transport cover, then close the top cover.