- ページ 15

ソフトウェア Xerox 3825のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Xerox 3825 28 ページ。 Xerox 3812: user guide

Defining a logical printer

Xerox DocuSP IPDS User Guide

Before using DocuSP IPDS to process IPDS data streams, the host

must have a logical printer defined for DocuSP IPDS with the

following requirements:

•

For TCP/IP connectivity, the Internet Protocol (IP) address and port

number of the logical printer must match the IP address and port

number of the printer. Valid values are 5001 through 65535.

•

For channel connectivity, the unit address specified for the host

printer definition must be a unique value and must match the unit

address specified on the DocuSP IPS Manager.

•

For MVS, the logical printer must be defined as an AFP-type device.

TCP/IP and channel connectivity can be established in the IPS

Manager System pull-down menu, System Configuration dialog box.

The following steps should be completed for a successful installation

of the DocuSP IPDS software, and proper queue and printer setup:

•

Ensure that the IPDS Interpreter license file has been loaded, and

that IPDS is active and enabled in the DocuSP Feature Manager.

•

Install the IPS Manager software. The Xerox Service Representative

performs this task.

•

Ensure a streaming print queue is defined on the DocuSP for your

system. You can view this queue by using the DocuSP Queue

Manager. This print queue initially has an Accept value of Yes and a

Release value of Yes.

•

Ensure that no overrides are set on the queue for any of the

properties defined earlier in this section.

To verify that the installation and initial setup are successful, print

both a host job and either the US Letter or the A4 sample job. If both

print successfully, installation verification is complete.

In addition, if you installed the IBM AFP resident outline fonts, print

the scfont.trc sample job to verify that the fonts were loaded correctly.

Installation and setup

2-7