- ページ 27

ソフトウェア Xerox DocuPrint 135のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Xerox DocuPrint 135 38 ページ。 Tape client job submission guide enterprise printing system
Xerox DocuPrint 135 にも：仕様 (2 ページ), 操作マニュアル (34 ページ), リファレンス・マニュアル (2 ページ), プランニング・マニュアル (20 ページ), リファレンス・マニュアル (42 ページ), クイック・リファレンス (2 ページ), 補足マニュアル (48 ページ)

Installation process

NPS/IPS Extension Operations Guide

For detailed information about defining the printer to your specific

host and connectivity requirements, refer to "Preparing for

installation" in the DocuPrint NPS/IPS Installation Planning

Guide.

To efficiently install and set up the NPS/IPS Extension option on

your 100/115/135/155/180 EPS system, certain activities need to

be performed by you and by Xerox.

Xerox is responsible for the physical installation of the NPS/IPS

Extension hardware and IPS/NPS software. The steps in the

installation process typically occur in the following order:

1. Xerox personnel install the NPS/IPS software and the NPS/

IPS Extension hardware.

2. Xerox personnel obtain a software license authorizing you to

use the IPS/NPS software.

3. Xerox personnel connect the printing system to the network

or channel.

4. Xerox personnel and you configure the printing system,

clients, or IBM host as applicable to submit jobs.

5. Xerox personnel conduct initial operator training.

For detailed information about the activities that you and Xerox

personnel perform during installation, refer to Installation in the

Xerox DocuPrint NPS/IPS Installation Planning Guide.

When the NPS/IPS software is purchased, the owner needs a

license to use it. Until the license is enabled at the printing

system, the printer does not process jobs.

NOTE: Software licenses are required for the NPS/IPS

Extension. Refer to your Xerox DocuPrint NPS/IPS Installation

Planning Guide for further information on licenses.

Installation planning

2-3