- ページ 31
ソフトウェア Xerox DocuPrint 155のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Xerox DocuPrint 155 34 ページ。 Tape client job submission guide enterprise printing system
Xerox DocuPrint 155 にも： 操作マニュアル (38 ページ), 仕様 (2 ページ), リファレンス・マニュアル (2 ページ), プランニング・マニュアル (20 ページ), リファレンス・マニュアル (42 ページ), クイック・リファレンス (2 ページ), 補足マニュアル (48 ページ)
ページを印刷する
Mode switching problems
Information to have when calling for service
NPS/IPS Extension Operations Guide
4 Problem solving
This chapter describes how to solve some specific problems that
may occur when you are switching from one mode to another.
Use the following information if you experience problems when
switching print modes.
Table 4-1 Mode switching problems
Condition
Does not boot
from EPS to
NPS/IPS print
mode.
In the United States, if you are unable to correct the problem, call
the following number:
1-800-822-2979
For customers outside the United States, call your local service
representative. A model-specific phone number is attached to
your printer at installation time.
Before you call, make note of the following:
•
Status code numbers and messages that appear on the
controller screen and the printer console
•
Indicator lights that are lit
Possible causes
External rigid disk
drive is not powered
ON (LED on the right
front of the external
disk drive is not
illuminated).
SCSI cable between
external rigid disk
drive and processor
is not properly
connected.
Corrective actions
Ensure that the drive is
plugged into the power
strip at the rear of the
controller stand.
Ensure that the SCSI
cable is connected to
the single-ended SCSI
connector on the rear
of the processor unit.
4-1