- ページ 4
プリントサーバー Xerox DOCUCOLOR 12のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Xerox DOCUCOLOR 12 8 ページ。 Carrier
Xerox DOCUCOLOR 12 にも: 仕様 (2 ページ), リファレンス・マニュアル (10 ページ), クイック・スタート・マニュアル (5 ページ), マニュアルの使用 (12 ページ), 補足マニュアル (4 ページ), 補足マニュアル (18 ページ), マニュアルを知る (24 ページ)
![Xerox DOCUCOLOR 12 クイック・スタート・マニュアル](/uploads/products/server2/7042520/7042520.png)
4 Quick Start Guide
UNIX (TCP/IP) workstation
IPX (Novell) network
Preparing to print
To set up your Fiery, you must perform the following tasks:
• Connect the Fiery physically to a functioning network.
• Configure the network server.
• Set up the Fiery from the Control Panel.
• Prepare client workstations for printing.
A brief explanation of each task follows.
Connecting the Fiery to a functioning network
N
already installed a network cabling system and has connected workstations and servers. For
examples of different networks, see the
• Prepare a network node for the Fiery.
• Route the cable to a location near the copier where the Fiery will be installed and attach
• Connect the Fiery to the copier and print a test page.
T
O PREPARE FOR
1. Print a copier test page to verify the copier is functioning normally.
2. Turn off the copier and connect the interface cable from the copier to the Fiery.
3. To confirm this connection, turn on the copier and the Fiery and print a Test Page from the
Fiery Control Panel.
To print a Test Page, press the Menu button on the Control Panel to access the Functions
menu. Choose Print Pages, and then choose Test Page.
4. With both the copier and the Fiery turned off, connect the network cable to the Fiery.
The network should already be installed and operational.
5. Turn on the copier and then the Fiery.
Other Network Requirements
• Standard TCP/IP connectivity (for example, Sun SPARCStation or Silicon Graphics
workstation with Solaris version 2.5 or later or SunOS version 4.1.x software)
• TCP/IP printing software that conforms to RFC1179 (Berkeley lpd protocol)
• Novell server
• Novell NetWare software version 3.x, 4.x, or 5.x
• Support for Ethernet SNAP, Ethernet II, Ethernet 802.3, and Ethernet 802.2 frame types
When you add the Fiery to a network, it is assumed that a network administrator has
:
OTE
the cable to the network interface of the Fiery.
For more information, see Chapter 1 of the
For detailed instructions, see the
F
IERY CONFIGURATION
Configuration Guide
.
Configuration Guide
Configuration Guide
.
.
Part Number: 45025694