セキュリティシステム Alderon Industries 8059のPDF 操作、メンテナンス、設置マニュアルをオンラインで閲覧またはダウンロードできます。Alderon Industries 8059 2 ページ。 Pump station alarm

Pump Station Alarm

Outdoor Remote Alarm Panel

Part Number - 8059

Operation, Maintenance and Installation Manual

Introduction

Alarm

Silence

Safety Guidelines

1. DISCONNECT ALL POWER SOURCES BEFORE WORKING ON OR INSTALLING THE ALARM PANEL.

2. DO NOT USE WITH FLAMMABLE OR EXPLOSIVE FLUIDS SUCH AS GASOLINE, FUEL OIL, KEROSENE,

ETC. DO NOT USE IN EXPLOSIVE ATMOSPHERES.

Description of Operation

The outdoor rated Remote Pump Station Alarm Panel is connected to either dry or 120 VAC powered contacts

from a pump basin "Main Control Panel".

The dry contacts from the "Main Control Panel" must be rated for 120 VAC, 1 Amp Minimum. The panel is

designed to be connected and field configured for Dry (Normally Open) or 120 VAC powered signals from the

"Main Control Panel".

When the signal is received from the "Main Control Panel", the alarm indicator, alarm buzzer and auxiliary

contacts activate. Pressing the Alarm Silence pushbutton silences the buzzer, but the alarm indicator and auxiliary

contacts remain activated.

When the signal from the "Main Control Panel" deactivates, the alarm indicator and auxiliary contacts turn off and

then auto resets the alarm buzzer for the next alarm cycle. The auxiliary contacts in the remote alarm can be used

to connect to auto dialers or Building Automation Systems (BAS).

Installation of Pump Station Alarm

1. Determine mounting location for the alarm panel and mount to a wall or wall structure. The panel has flanges

on the top and bottom which have mounting holes, use appropriate fasteners to securely mount the enclosure

to the wall or wall structure.

2. Determine conduit entrance locations on the alarm panel and install per local codes. Check schematic and

determine the number of power sources required. Use conduit sealant on all conduits to prevent moisture and

gases from entering the alarm panel.

3. Connect wires (recommended THHN 18 AWG wire) from the main control panel to the alarm panel, refer to

Figure 2 and Figure 3 on Page 2 for wiring options.

4. Verify correct wiring after installation is complete by activating the main panel alarm system, the remote alarm

panel should activate.

Alarm Systems

Control Panels

PO Box 827 Hawley, MN 56549 (218) 483-3034 Fax (218) 483-3036 www.alderonind.com

Before proceeding with the installation or operation of the Pump Station Alarm

Panel, read all instructions thoroughly, as well as complying with all Federal, State

and Local Codes, Regulations and Practices. The control panel must be installed

by qualified personnel familiar with all applicable local electrical and mechanical

codes. Refer to the National Electrical Code (NFPA 70). Failure to properly install

and test this product can result in personal injury or equipment malfunction.

Float Switches

Leak Detection Systems

Page 1 of 2