コントロールパネル Alderon Industries Check It PanelのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Alderon Industries Check It Panel 6 ページ。 1 phase simplex demand dose

Check It Panel

1 Phase Simplex Demand Dose

Operation, Maintenance & Installation Manual

Introduction

Before proceeding with the installation or operation of the control panel read all instructions thoroughly,

as well as comply with all Federal, State and Local Codes, Regulations and Practices. The control panel

:must be installed by qualiﬁed personnel familiar with all applicable local electrical and mechanical

codes.Refer to the National Electrical Code (NFPA 70). Failure to properly install and test this product can

result in personal injury or equipment malfunction. All conduit connected to the panel must be sealed

with conduit sealant to prevent moisture or gases from entering the panel. NEMA 1 enclosures are for

indoor use only while NEMA 4X panel enclosures may be used indoor or outdoor. Refer to panel model

name plate on inside of door for enclosure rating. Note: If options are ordered that affect the number of

ﬂoats, refer to the panel schematic for complete information.

Safety Guidelines

1. DO NOT USE WITH FLAMMABLE OR EXPLOSIVE FLUIDS SUCH AS GASOLINE, FUEL OIL, KEROSENE,

ETC. DO NOT USE IN EXPLOSIVE ATMOSPHERES. CONTROL PANEL SHOULD ONLY BE USED IN

WATER AND WASTEWATER APPLICATIONS THAT ARE NOT RATED AS A HAZARDOUS LOCATION.

2. DO NOT WORK ON THE CONTROL PANEL WITH LIVE VOLTAGE APPLIED TO THE CONTROL PANEL

WITH WET HANDS OR WHEN STANDING ON A WET SURFACE.

3. DISCONNECT ALL ELECTRICAL SERVICE BEFORE WORKING ON OR HANDLING THE CONTROL PANEL

4. INCOMING VOLTAGE MUST MATCH THE CONTROL PANEL VOLTAGE. REFER TO THE PANEL SCHE-

MATIC FOR COMPLETE INFORMATION.

Installation of the Control Panel:

Determine mounting location for the control panel. Attach the 4 mounting feet to the

control panel enclosure. If splicing is required between the level switches and the panel,

we recommend an Alderon Junction box. CAUTION! Use conduit sealant and waterproof

wire nuts for connections. Make sure all connections are water tight.

Determine conduit entrance locations on control panel and install per local codes. Check

schematic and determine number of power sources required. Use conduit sealant on all conduits

to prevent moisture and gases from entering control panel.

Connect control/alarm and pump power conductors to the proper terminals. The sche

matic and terminal blocks will be labeled for proper connection.

Verify correct panel operation after installation of panel, power and level switches are

complete.

P/N L1153

Page 1 of 6