- ページ 6
スイッチ Alderon Industries 2000275のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Alderon Industries 2000275 16 ページ。 Plastic cable weight control and pump switches
ページを印刷する
Plastic Cable Weight - USER GUIDE
Installation
DISCONNECT ALL POWER SOURCES WHEN INSTALLING OR SERVICING THIS PRODUCT. FAILURE TO
TURN OFF ALL POWER SOURCES COULD RESULT IN SERIOUS INJURY OR DEATH.
Installing Float Switch Cable
STEP 1: REMOVE CABLE CLIP
Remove cable clip from the cable weight by lifting tab upward until it releases from the notch (1A; do not exceed more than a
20 degree angle) and pull directly away (1B).
1A
STEP 2: TETHER LENGTH
Determine the desired activation level, place float switch cable in slot of the cable weight with cable clip removed, and tether
float switch to the appropriate length. Refer to the instructions that came with the float switch for recommended tether length
guides to determine activation or pumping range.
6 | Alderon Industries™ - Leading Edge Control Products
(lift)
Tether
Length
1B
Control Switches (Narrow Angle)
Minimum recommended tether length is 3.5 inches
Pump Switches (Wide Angle)
Minimum recommended tether length is 3.5 inches
(slide)