- ページ 6

セキュリティシステム Direct Supply AttendantのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Direct Supply Attendant 12 ページ。 Pen light
Direct Supply Attendant にも：オーナーズマニュアル (2 ページ), オーナーズマニュアル (12 ページ), オーナーズマニュアル (8 ページ), オーナーズマニュアル (2 ページ), オーナーズマニュアル (2 ページ), オーナーズマニュアル (2 ページ), オーナーズマニュアル (2 ページ)

Directions for Use

NOTE: A stethoscope (not included) is necessary to properly

obtain a blood pressure reading.

1. Place the cuff about 1 inch above the bend of the

resident's left elbow. Ensure no clothing is between the

cuff and the resident's arm. Check for correct fit by making

sure you can insert two fingers between the cuff and skin

surface and also make sure that the

above the resident's artery.

2. T o ensure that the correct cuff size is used, check to see

that the white index line lies in between the arrows on the

cuff after the cuff has been placed on the resident. If the

line fails to reach the range, change to a larger cuff. If the

line is beyond the range, change to a smaller cuff.

3. C lose the air release valve attached to the inflation bulb

by turning it clockwise. Pump air into the system by

repeatedly squeezing the bulb until the pressure reading

on the manometer is about 20 mmHg above the expected

systolic blood pressure. Place the chest piece of the

stethoscope on the artery under the cuff.

4. Slowly open the air release valve by turning it counter-

clockwise so that the gauge needle descends at a rate

of 2-3 mmHg/second. Listen to the pulse. When the first

thumping sound is heard, note the reading of the gauge.

This is the systolic blood pressure. When the rhythm

thumping sound is not heard again, note the reading on

the gauge. This is the diastolic blood pressure.

5. Open the air release valve completely so that air

can escape from the cuff quickly. The blood pressure

measurement procedure is now complete.

symbol is directly