計測機器 Alderon Industries Mini Power Post PRPT-00003のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Alderon Industries Mini Power Post PRPT-00003 2 ページ。 Pump connection center
Alderon Industries Mini Power Post PRPT-00003 にも：ユーザーマニュアル (16 ページ)

ページを印刷する

Mini Power Post

Pump Connection Center | Model: PRPT-00003

QUICK START GUIDE

Step 2: Remove Bottom Cover

Remove the bottom enclosure cover screw, slide the cover directly

downward (2A) and pull directly away from the enclosure (2B).

Step 3: Install Wire into Wago Connector

1) Lift tab(s) upward.

2) Insert wire(s) into slot.

3) Press tab(s) downward.

4) Make sure wire(s) are secured.

™

TO OPEN

TO CLOSE

WAGO

Safety Guidelines

Before proceeding with the installation or operation of this product,

read all instructions thoroughly, as well as complying with all federal,

state and local codes, regulations, and practices. This product must

be installed by qualified personnel familiar with all applicable local

electrical and mechanical codes. Refer to the National Electrical Code

(NFPA 70). Failure to properly install and test this product can result in

personal injury or equipment malfunction.

Step 1: Install Post

Determine location for the post in the

ground near a tank and drill access

holes for the float switch cables using

the customer supplied conduit/fittings or

Alderon's riser connection kit. Route the

cables through access holes and wire

as described in step 4.

Note: Seal all conduits to prevent moisture and gases

from entering the post per local codes.

Step 4: Junction Box Wiring

1) Route alarm float switch cable through Cable Grip A and firmly

tighten grip.

2) Route the underground feeder (UF) cable from the indoor alarm

panel through Cable Grip B and firmly tighten grip.

3) Route incoming pump power UF cable through Cable Grip D and

firmly tighten grip.

4) Connect wires in Cable Grip D to the pre-installed Wago

connectors on wires coming out of Cable Grip C as shown in the

diagram.

5) Connect wires coming in Cable Grip A to wires coming in Cable

Grip B as shown in the diagram.

Note: NEVER leave ground wire(s) exposed, use provided Wago

connectors for wire termination (see step 3).

WAGO

BLACK

WAGO

WHITE

WARNING

BLACK

WHITE

WAGO