- ページ 7

スピーカー ALDERWOOD Eros ProのPDF マニュアルをオンラインで閲覧またはダウンロードできます。ALDERWOOD Eros Pro 12 ページ。 Hand crafted sound

1) Take the brass wall mount out of its packaging and locate the

2mm allen key in wall mounting kit

2) Use the 2mm allen key to loosen a few turns of the M4 grub

screw located halfway on the side of the brass bracket, this should

only be finger tight from factory. Take care not to loose the grub

screw, a spare is provided in kit if one is lost.

3) You should now be able to slide the wall fixture out of the

back of the bracket, this is the part you will screw firmly to

the wall. Supplied in the kit is a wall screw 70mm x 8g this is

designed to be long enough to go through plaster and secure to

a wall stud, if being installed into an older home with a hardwood

frame, pre drilling the mounting hole with a 2mm drill bit may

make installation easier, hand tightening with a Phillips head screw

driver is recommended.

4) Re-assemble bracket with parts removed in step 2. Before

tightening the allen key try to point the threaded end to a position

that will allow for the Eros Pro to be threaded on with ease.

5) Remove your Eros PRO from packaging. On the back in the

center you will find a phillps head bolt. This is to be removed

with a screwdriver to expose the mounting thread. Under no

circumstances can the speaker be used without either the phillps

head bolt or the wall mount in place, this speaker cabinet runs at

high pressure and running the speaker depressurized can damage

your speaker and degrade its sound.

6) Carefully line up the back of the Eros PRO to the wall bracket

thread and gently turn the Eros Pro clockwise from front to thread

in place. Care must be taken not to cross thread the Eros Pro when

starting to turn. Thread on until firm, if ball mount starts to spin

you can tighten it further with the allen key and the proceed to

thread the Eros until firm (If thread gets tight and wont allow the

Eros Pro to be fully threaded in place the thread might be cross