- ページ 9
ケーブルとコネクター eControls ECOM E2046013のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。eControls ECOM E2046013 12 ページ。 Ecom driver installation
ページを印刷する
- 1. Table of Contents
- 1. 1 Introduction
- 2. 2 Ecom Tm Installation Procedure
- 2. Running the Setup Program
- 2. Connecting the ECOM
- 2. Verifying ECOM™ Installation
- 3. 3 Troubleshooting Ecom Tm Issues
- 3. General Troubleshooting
- 3. Windows 10 Driver Installation Issues
- 3. Windows 7 Driver Installation Issues
00: CUSTOMER
(see detail on Title Page)
2.2
Connecting the ECOM
The first time you insert an ECOM
hardware installation for that specific ECOM
A Found New Hardware ECOM
Hardware E2046000 Communications Device bubble – should appear at the bottom of your
computer screen, indicating that it recognizes the ECOM
Subsequently a bubble should appear at the bottom of your computer screen message will appear
stating that the drivers are installed and the new hardware is ready to use.
A message may appear asking you if you want to restart your computer to enable you to use the
new software.
If you are planning on using the ECOM
Otherwise it is safe to select [
software that uses the ECOM
EControls LLC. Confidential and / or proprietary information. Do not copy or distribute without prior written approval.
TM
ECOM
Driver
Installation Manual
TM
TM
device into a new USB slot, Windows will complete the
TM
and port.
TM
Communications Device bubble – followed by a Found New
TM
at this time select [
and wait until a later time to reboot. Until you do so, any
No]
TM
may not function properly.
Doc. No. ER000060_00 Rev E1-
TM
device.
.
Yes]
Page 9 of 12